04/08/2002 Multilevel wiring solution
In order to prevent the wires from an upper level from fouling trains below, I partially screwed a series of 1/4" screws into the underside of the upper layer before installing the board. Then when I lay track above, I drill through and thread the wire through the hole and then lead it to the nearest screw, wrap it around twice and pass the end between itself and the board and then lead it down to below the lowest level where I tap into the bus lines...


Related pages....
Wiring the IB plug
Central section framing and wiring
Loom wiring and pigtail connectors
Booster plug
shim contact
Multilevel wiring solution
Wire taps
Laying K-Track
LED building lighting
Changing wire color
Variable voltage DC power supply
Shunt Voltage Regulator
distribution center
Power supply with distribution panel
5.15 Volt DC power supply
Voltage visualization
Stationary decoder
Determining LED circuit resistor
Tunnel signal
5 Volt power regulator
Welder simulator
Resistor values for white LED circuits
Source of fine wire


Trains: Layout Home | RemoteSign | BW Lite Intellibox software | Märklin Guide | Crud-B-Gone
Other: Doings | Genealogy | Wilsnack | Cape Griffon | Art | Dale | Blog


Photographs are Copyright by Dale Schultz or Debbie Broderick. Images may be saved and or printed for personal use only.
This page is http://layout.mixmox.com/1/20020408Multilevelwiringsolution